Journal of Earth Sciences and Geotechnical Engineering

Bearing Capacity Affecting the Design of Shallow Foundation in Various Regions of Iraq Using SAP200 & SAFE softwares

• [ Download ]
• Times downloaded: 11412

• Abstract

  Bearing pressure is the load per unit area along the foundation bottom. The value of bearing pressure can be obtained from soil exploration. In this research, three sites in Iraq were tested (Mosul at north, Baghdad at middle and Basrah at south) for the best type of foundation to be chosen. Seventy nine samples were taken from twenty three boreholes drilled to a depth ranging from 1to 24m, from various sites for the three sites. Samples were tested for their size; Atterberg limits; direct shear; unconfined compression; consolidation and SPT tests. The results showed that the nature of soil in Mosul was generally were silty clay to clay (in some areas silt or sand) with high to very high plasticity. In Baghdad, it was loam clay, silty clay, and in some areas silt. Its plasticity range was medium to high and non-plastic in few sites. For Basrah, the soil type was clay loam and in many places was sand or silt. The value of plasticity was medium. The average and the worst values of bearing capacity were: 177KN/m2 and 77KN/m2 for Mosul; 125 KN/m2 and 68 KN/m2 for Baghdad; and 84KN/m2 and 24 KN/m2 for Basrah. These values were used in a computer model (SAP2000 and SAFE softwares) to find the best suitable foundation in each site. The model suggests that spread or continuous and raft (if basement is used for building with many floors) are suitable for Mosul. For Baghdad, spread and raft type of foundations are suitable. While, for Basrah, raft foundation type are to be used in some areas where building should be less than three floors and for other areas, deep foundation (piles or pier) can only to be used.